How to add Microsensor

Adding a Microsensor to your LEXI app is easy

Open your LEXI app, click Add a Device and select LEXI.

 

Select Sensors option, then select Zigbee and click Next.

 

Please reset the Microsensor so it gets into pairing mode.

To reset your Microsensor, please follow the steps give below:

1. Press and release the reset button (by inserting a small pin into the pinhole on the side of the device) and the LED will flash once.
2. Repeat the reset step for a total of 5 times.
3. On successful reset, the Microsensor LED will begin flashing red.
   
4. The LED will start blinking faster once the Microsensor gets into pairing mode and then stop blinking when it is getting added.
   

Once your Microsensor device is added, make sure you add a unique name to each device so you can recognize it later and control it better.

 

• Related Articles

• How to reset Microsensor

  You can easily reset your Microsensor to bring it to factory default settings. To reset your Microsensor, please follow the steps give below: Press and release the reset button (by inserting a small pin into the pinhole on the side of the device) and ...

• How to add Smart Camera

  Adding a Smart Camera to your LEXI app is easy Power on your Smart Camera and ensure it is in the pairing mode (LED light flashing Red). If the Red LED light is not blinking, please reset the camera to put it into pairing mode. Open your LEXI app and ...

• How to add Zigbee Smart Switch

  Adding a Smart Switch to your LEXI app is easy Make sure your Smart Switch is in the pairing mode (Red light flashing). If the Red LED light is not flashing, reset it by pressing the reset button for 5 seconds until the Red LED light starts blinking ...

• How to add Smart Water Leak Sensor

  Adding a Smart Water Leak Sensor to your LEXI app is easy Make sure your Smart Water Leak Sensor is in the pairing mode (Red light flashing). If the Red LED light is not flashing, reset it by pressing the reset button for 5 seconds until the Red LED ...

• How to add Smoke Sensor

  Adding a Smoke Sensor to your LEXI app is easy Make sure that your Smoke Sensor is in the pairing mode (Green light flashing). If the Green LED light is not flashing, press the reset button through the pin hole for 5 seconds until the LED light turns ...